How to Glue Carbon Fiber Rods

Carbon fiber rods are used in a number of ways in model building, both for static kit builders looking for additional support for their structures and by RC modelers who use them to reinforce airplane wings and strengthen car frames. Carbon fiber rods are are made by tightly combining carbon fibers with epoxy resin. As a result, they are incredibly strong and lightweight, but they can be a little difficult to bond if you do not know what you are doing. Fortunately, the process is fairly simple.

Instructions

    • 1

      Cut the ends of the rod flush using a high-speed rotary tool and a high-density cut off wheel, if necessary.

    • 2

      Scuff the surface of both connecting ends using medium grit sand paper.

    • 3

      Wipe down both rods on a clean rag with rubbing alcohol, and allow to dry.

    • 4

      Mix a slow-set epoxy and apply to the carbon rod connection points with a toothpick. You also may use thin cyanoacrylate glue, though slow-set epoxy will give a stronger bond.

    • 5

      Allow to cure for at least an hour before testing.

 
Hits: 1250   UpdateTime:2022-07-05 07:39:30  【 Printing 】  【 Close

Bestwill Composites Co.,Ltd  Copyright@ 2022-2025. Email: [email protected]